High-Power Motor Purchase Requirements
The sale of 'G' motors and larger and all model and high power RMS reload kits to persons under 18 years of age is currently prohibited by federal law. Individuals must be 18 years of age to purchase high power hardware. Proof of age (such as a copy of a driver's license) must accompany all orders for 'G' and larger motors and all RMS reload kits. The consumer must be a current member in either the National Association of Rocketry or Tripoli Rocketry Association and be certified Level 1 (H,I), or Level 2 (J,K,L), or Level 3 (M,N,O) high power user, 18 years of age or older to purchase all high power reload kits.
Please note that orders requiring additional documentation cannot be shipped without a copy of a NAR or Tripoli Rocketry Association Level Certification card, or evidence (business license or purchase order on company or school letterhead) that you are a legitimate business or academic customer.
Launch Your Adventure
Description
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Unscrew top from nozzle. For finer applications, use the extender tip. Apply Insta-Cure+™ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set™ accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220° F. Soak extender tip in acetone for cleaning.
Rocket
Motors, Kits &
Components!
- Choosing a selection results in a full page refresh.
- Opens in a new window.