Aerotech 18-38mm RMS Delay Drilling Tool to trim delays in RMS and RMS-Plus reload kits.
Any pictures displayed are for reference only and may be different from the product shown for sale. Customers are responsible for verification.
Aerotech 18-38mm RMS Delay Drilling Tool to trim delays in RMS and RMS-Plus reload kits.
Any pictures displayed are for reference only and may be different from the product shown for sale. Customers are responsible for verification.
Quality is good but no instructions on how to use it. Emailed Aerotech and they responded with the instructions for the RMS-PLUS 38mm reload system. Even these instructions are vague and implies this toll is not for 18,24 or 29mm motor delays.
There is calibration instructions included.
As sold this removes 2, 4, 6 or 8 seconds from a delay grain.
One end is to remove 4 seconds and the other end removes 8 seconds. By inserting the 0.060 inch thick spacer these are reduce to 2 second or 6 second. Would be nice to have 1 second increments which could be done with a 0.030 inch thick spacer.
